Robotpark UNO R3 Kombo Kit (Adaptor + USB Cable)

0 reviews  (0/5 ) 0 reviews  •  Write a review
Product Code: 91092-A
Availability: SOLD OUT Views: 16015
Product Description
  • Robotpark microcontroller module with USB connection
  • Wide variety of accessory "Shields" available
  • Variety of I/O pins including analog, digital, PWM and more
  • Based on the ATmega328 (removable DIP IC)
  • Revision 3
  • USB cable and power adapter included
$16.00
Qty:

Shipping Options to United States

Select Country:
* Region / State:

Robotpark UNO R3 Kombo Kit (Adaptor + USB Cable) info

Robotpark Uno is a microcontroller board based on the ATMega328 microcontroller. It has 14 digital input/output pins of which 6 can be used as PWM outputs, 6 analog inputs, a 16 MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and a reset button. To get started using your board, simply connect it to a computer with a 1.5m USB Cable Type A to B or power it with an external power supply from the power jack.

Robotpark Uno differs from all preceding boards in that it does not use the FTDI USB-to-serial driver chip. Instead, it features the ATMega16U2 programmed as a USB-to-serial converter.

Robotpark Uno can be powered via the USB connection or with an external power supply. The power source is selected automatically. External power can come either from an AC-to-DC adapter or battery. The adapter can be connected by plugging a 2.1mm center-positive plug into the board's power jack. Leads from a battery can be inserted in the Gnd and Vin pin headers of the POWER connector. The board can operate on an external supply of 6 to 20 volts.

Robotpark Uno can be programmed with the Arduino software. ATMega328 on the Robotpark Uno comes preburned with a bootloader that allows you to upload new code to it without the use of an external hardware programmer.

 

Robotpark UNO R3 Kombo Kit - General Specifications

  • Robotpark microcontroller module with USB connection
  • Wide variety of accessory "Shields" available
  • Variety of I/O pins including analog, digital, PWM and more
  • Based on the ATmega328 (removable DIP IC)
  • Revision 3
  • USB cable and power adapter included

 

Robotpark UNO R3 Kombo Kit - Technical Specifications

  • Microcontroller: ATmega328
  • Operating Voltage: 5V
  • Input Voltage (recommended): 7-12V
  • Input Voltage (limits): 6-20V
  • Digital I/O Pins: 14 (6 PWM)
  • Analog Input Pins: 6
  • DC Current per I/O Pin: 40 mA
  • DC Current for 3.3V Pin: 50 mA
  • Flash Memory: 32 KB
  • SRAM: 2 KB
  • EEPROM: 1 KB
  • Clock Speed: 16 MHz

 

Videos

 

Documents

 Arduinu Uno R3 Schematic

 

References

Arduino Web Site

http://arduino.cc/en/Main/arduinoBoardUno

There are no reviews for this product.
Write a review Your Name:


Your Review:Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: