USB LiIon/LiPoly Charger - v1.2

USB LiIon/LiPoly Charger - v1.2 info

USB LiIon/LiPoly Charger - v1.2 is a Lithium Ion and Lithium Polymer battery charger based on the MCP73833. It uses a USB mini-B for connection to any computer or 'USB wall adapter'. Charging is performed in three stages: first a preconditioning charge, then a constant-current fast charge and finally a constant-voltage trickle charge to keep the battery topped-up. The fast-charge current is 500mA by default, but is easily adjustable from 100mA up to 1000mA by soldering a through-hole resistor on-board.

USB LiIon/LiPoly Charger - v1.2 is great for DIY projects because it has 3 indicator LEDs - one for power, one for charging status and a third that indicates when charging is complete. Keep the battery connected to the charger and pass power through the additional JST connector.

Note: USB LiIon/LiPoly Charger - v1.2 is for use with Adafruit Li-Poly batteries only. Other batteries may have different voltage, chemistry, polarity or pinout.

USB LiIon/LiPoly Charger - v1.2 - General Specifications

• Comes assembled and tested, includes a JST cable
• 5V input via mini-B USB connector
• For charging single Lithium Ion/Lithium Polymer 3.7/4.2v batteries (not for older 3.6/4.1v cells)
• 500mA charge current, adjustable from 100mA to 1000mA by soldering in a resistor
• Separate JST connectors for battery and load system so batteries don't have to be removed for charging
• Chip supports a 10K NTC thermistor which have been stuffed as a plain 10K. For people who require temperature monitors (using high charge rates), remove the 10K and solder in the thermistor in its place
• 0.1" (2.54mm) breakouts for the battery, DC, and status LEDs
• Free 2-pin JST cable included

USB LiIon/LiPoly Charger - v1.2 - Technical Specifications

• Dimensions: 33mm x 35mm x 7mm

Videos

Documents

MCP73833 Datasheet

Adafruit Tutorial

References

Adafruit Web Site: https://www.adafruit.com/products/259