ST-LINK V2 CN

ST-LINK V2 CN info

ST-LINK V2 Programmer for STM8 and STM32

ST-LINK / V2 is an on-chip debugger and programmer for the STM8 and STM32 microcontroller families. Single wire interface module (SWIM) and JTAG / serial wire debug (SWD) interfaces are used to communicate with any STM8 or STM32 microcontroller on an application card.

STM8 applications use the USB interface to communicate with STMicroelectronic ST Visual Development (STVD) or ST Visual Program (STVP) software.

STM32 applications use the USB interface to communicate with Atollic, IAR, Keil or TASKING integrated development environments.

Features

• 5 V power supplied by a USB connector
• USB 2.0 full-speed compatible interface
• USB standard A to mini B cable

SWIM-specific features

• 1.65 V to 5.5 V application voltage is supported on the SWIF interface
• SWIM low speed and high speed modes supported
• SWIM programming speed: 9.7 Kbytes / s in low speed and 12.8 Kbytes / s in high speed
• To connect the application to the SWIM cable using a pin head or a 2.54 mm connector

    
JTAG specific features

• At the JTAG interface 1.65 V - 3.6 V application voltage is supported and 5 V tolerant inputs
• JTAG cable for a standard JTAG 20-pin 2.54 mm connector connection
• Supported direct firmware update feature (DFU)
• Flashing status LED when communicating with PC
• Operating temperature 0 to 50 ° C