Long Flex/Bend Sensor

Long Flex/Bend Sensor info

Long Flex/Bend Sensor can detect bending in one direction. They were popularized by being used in the Nintendo PowerGlove as a gaming interface.

Long Flex/Bend Sensor s are easy to use, they are basically resistors that change value based on how much they are flexed. If they're unflexed, the resistance is about ~10KΩ. When flexed all the way the resistance rises to ~20KΩ. You can use an analog input on a micro-controller (with a pullup resistor) or a digital input with the use of a 0.1uF capacitor for RC timing.

The bottom part of the sensor (where the pins are crimped on) is very delicate so make sure to have strain relief - such as clamping or gluing that part so as not to rip out the contacts!

Long Flex/Bend Sensor - General Specifications

• Flexible bending sensor
• Resistance varies with bending
• Can be connected to a microcontroller analog or digitally

Long Flex/Bend Sensor - Technical Specifications

• Length: 112.5mm
• Width: 6.38mm
• Thickness: 0.5mm
• Weight: 0.5g

Documents

Datasheet

References

Adafruit Web Site: https://www.adafruit.com/products/182