INA219 High Side DC Current Sensor Breakout - 26V ±3.2A

0 reviews  (0/5 ) 0 reviews  •  Write a review
Product Code: 91539
Availability: SOLD OUT Views: 16714
Product Description
  • High side current sensing
  • Adjustable range and resolution
  • Easy to use
  • Internal 12bit AD converter
  • 3.5mm terminal plug
$11.00
Qty:

Shipping Options to United States

Select Country:
* Region / State:

INA219 High Side DC Current Sensor Breakout - 26V ±3.2A info

INA219 High Side DC Current Sensor Breakout - 26V ±3.2A will solve all your power-monitoring problems. Instead of struggling with two multimeters, you can just use the handy INA219B chip on this breakout to measure both the high side voltage and DC current draw over I2C with 1% precision.

Most current-measuring devices are only good for low side measuring. That means that unless you want to get a battery involved, you have to stick the measurement resistor between the target ground and true ground. This can cause problems with circuits since electronics tend to not like it when the ground references change and move with varying current draw. INA219 High Side DC Current Sensor Breakout - 26V ±3.2A is much smarter - it can handle high side current measuring, up to +26VDC, even though it is powered with 3 or 5V. It will also report back that high side voltage, which is great for tracking battery life or solar panels.

A precision amplifier measures the voltage across the 0.1 ohm, 1% sense resistor. Since the amplifier maximum input difference is ±320mV this means it can measure up to ±3.2 Amps. With the internal 12 bit ADC, the resolution at ±3.2A range is 0.8mA. With the internal gain set at the minimum of div8, the max current is ±400mA and the resolution is 0.1mA. Advanced hackers can remove the 0.1 ohm current sense resistor and replace it with their own to change the range (say a 0.01 ohm to measure up 32 Amps with a resolution of 8mA)

A 6-pin header is also included so you can easily attach this sensor to a breadboard as well as a 3.5mm terminal plug so you can easily attach and detach your load. Usage is simple. Power the sensor itself with 3 to 5VDC and connect the two I2C pins up to your microcontroller. Then connect your target power supply to VIN+ and the load to ground to VIN-. Adafruit has an Arduino library that will do all the gain, range and math for you. You can download the library using the link in the Documents section.

 

INA219 High Side DC Current Sensor Breakout - 26V ±3.2A - General Specifications

  • High side current sensing
  • Adjustable range and resolution
  • Easy to use
  • Internal 12bit AD converter
  • 3.5mm terminal plug

 

INA219 High Side DC Current Sensor Breakout - 26V ±3.2A - Technical Specifications

  • Target Voltage: Up to +26V
  • Current Measurement: Up to ±3.2A
  • Resolution: Up to ±0.8mA
  • PCB Size: 22.9mm x2 0.5mm
  • I2C Addresses: 7-bit 0x40, 0x41, 0x44, 0x45 selectable with jumpers

 

Documents

Adafruit Libraryhttps://github.com/adafruit/Adafruit_INA219

INA219B Datasheet

Adafruit Tutorial

 

References

https://www.adafruit.com/products/904

There are no reviews for this product.
Write a review Your Name:


Your Review:Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: