Arduino Ethernet Shield R3 with Micro SD Connector - Assembled - W5100 - Original Boxed

Arduino Ethernet Shield R3 with Micro SD Connector - Assembled - W5100 - Original Boxed info

Arduino Ethernet Shield R3 allows an Arduino board to connect to the internet. It is based on the Wiznet W5100 ethernet chip. The Wiznet W5100 provides a network stack capable of both TCP and UDP. It supports up to four simultaneous socket connections. Use the Ethernet library to write sketches which connect to the internet using the shield.

The new Ethernet shield now includes a micro SD card connector, it is Arduino Mega compatible and has an on-board reset controller.

The ethernet shield connects to an Arduino board using long wire-wrap headers which extend through the shield. This keeps the pin layout intact and allows another shield to be stacked on top.

Arduino uses digital pins 10, 11, 12, and 13 (SPI) to communicate with the W5100 on the ethernet shield. These pins cannot be used for general i/o.

Arduino Ethernet Shield R3 - General Specifications

• Wiznet W5100 Chip
• IEEE802.3af compliant
• Connection with Arduino on SPI port

Arduino Ethernet Shield R3 - Technical Specifications

• Operating Voltage: 5V
• Ethernet Controller: W5100 with internal 16K buffer
• Connection speed: 10/100 Mb
• Dimensions: 73mm x 54mm x 17mm
• Weight: 26g

Videos

Documents

Ethernet Shield Schematic

Ethernet Shield Guide

References

Arduino Web Site

http://arduino.cc/en/Main/ArduinoEthernetShield