Adafruit 16-Channel 12-bit PWM/SERVO ARDUINO SHIELD - I2C interface

Adafruit 16-Channel 12-bit PWM/SERVO ARDUINO SHIELD - I2C interface info

If you want to use your Arduino board to make a robot which has lots of moving parts or if you want to control too many LEDs with PWM outputs, the limited PWM outputs of your Arduino board would be a big problem for you. To overcome this problem, the only thing you should do is to get an Adafruit 16-Channel 12-Bit PWM/Servo Arduino Shield. Adafruit 16-Channel 12-Bit PWM/Servo Arduino Shield is the Arduino shield version of the Adafruit 16-Kanal 12-Bit PWM/Servo Driver. It is compatible with Arduino Uno, Arduino Leonardo and Arduino Mega.

You can control 16 free-running PWM outputs with Adafruit 16-Channel 12-Bit PWM/Servo Arduino Shield  using only 2 pins. You can even chain up 62 breakouts to control up to 992 PWM outputs. It's an I2C-controlled PWM driver with a built in clock. That means that, you do not need to continuously send it signal tying up your microcontroller, it is completely free running!

It is 5V compliant, which means you can control it from a 3.3V microcontroller and still safely drive up to 6V outputs. This is good for when you want to control white or blue LEDs with 3.4+ forward voltages. 6 address select pins so you can wire up to 62 of these on a single I2C bus, a total of 992 outputs.

Adafruit 16-Channel 12-bit PWM/Servo Arduino Shield - General Specifications

• Compatible with Arduino Uno, Arduino Leonardo and Arduino Mega
• Adjustable frequency PWM up to about 1.6 KHz
• 12-bit resolution for each output - for servos, that means about 4us resolution at 60Hz update rate
• Configurable push-pull or open-drain output
• Output enable pin to quickly disable all the outputs
• Terminal block for power input
• Reverse polarity protection on the terminal block input
• Green power-good LED
• 3 pin connectors in groups of 4 so you can plug in 16 servos at once
• Chainable design
• A spot to place a big capacitor on the V+ line
• 220 ohm series resistors on all the output lines to protect them, and to make driving LEDs trivial

Adafruit 16-Channel 12-bit PWM/Servo Arduino Shield - Technical Specifications

• Driver chip: PCA9685
• Dimensions: 54mm x 70mm x 3mm
• This board/chip uses I2C 7-bit address between 0x60-0x80, selectable with jumpers

Videos

Documents

PCA9685 datasheet

References

Adafruit Web Site

http://www.adafruit.com/product/1411